The Space Management Tab > Volumes commands display the Select from Catalog Dialog the first time you run a Volumes command in a session.
-
Click Space Management Tab > Volumes > Two Points Command to open the Place Volume by 2 Points Controls.
-
Click Browse Catalog to open the Select from Catalog Dialog.
-
Browse the catalog and select a volume type, and then click OK.
-
Select a space folder to define the active parent:
Click Space Folder > Select from Workspace to display the Workspace tab on the Select Space Folder Dialog. Select a space folder, and then click OK.
Click Space Folder > Select from Model to display the Model tab on the Select Space Folder Dialog. Select a space folder, and then click OK.
Click Select Parent System Interactively , and then select a space folder from the Space Hierarchy Explorer .
-
Specify a name for the volume in the Name box.
-
(Optional) Click Assoc Enabled to break the association between the volume and objects in the model. This is useful when placing volumes that you need to modify later. The control changes to Assoc Disabled . If you place a volume using Assoc Enabled , you need to break the association of each point in the volume before modifying it.
-
Click to define the first point of the rectangular volume.
-
Define the opposite corner of the rectangular volume.
-
Complete the placement:
-
Select Finish or press CTRL + ENTER to save your changes and exit the command.
-
Select Finish and Modify or press CTRL + SHIFT + ENTER to save your changes, and then start the modification of that object.
-
Select Finish and Repeat or press SHIFT + ENTER to save your changes, and then restart the command using the same options.
-