Bevel 
enables you to insert bevels into elements. Bevel is only available in the Parts work area. You must create bevels before turning elements
into profiles.
The software displays bevel types on elements in different colors in the work area so that you can distinguish them from each other. After you turn elements into profiles, the software displays different bevel icons on the profiles to indicate the bevel types. Point to a bevel icon to display a bigger preview image of the bevel in the work area.
Click Bevel to display the Create Bevel options (see below) in the State Manager.
Preview
Displays a preview of the bevel. Changes you make to the bevel properties take effect immediately in the preview image.
You can also click a value on the preview image. The software updates the corresponding parameter box. The Preview image is shown below.
Bevel Type
K Bevel
Y Bevel, upper level
V Bevel, upper level
I Bevel
X Bevel
Y Bevel, lower level
V Bevel, lower level
Bevel Parameters
Arranges bevel parameters into two columns. Depending on the selected bevel type, different sets of parameters are available. The right column specifies additional parameters for variable bevels. This column is available when you select Variable Bevel.
Left column
Angle 1
Specifies the angle of the upper bevel.
Angle 2
Specifies the angle of the lower bevel.
Length 1
Specifies the length of the upper bevel.
Length 2
Specifies the length of the root face.
Plate Thickness
Specifies the thickness of the plate.
Right column
Variable Angle 1
Specifies the angle on the end point of the upper bevel.
Variable Angle 2
Specifies the angle on the end point of the lower bevel.
Length 1
Specifies the length on the end point of the upper bevel.
Length 2
Specifies the length on the end point of the lower bevel.
Variable Bevel
Enables you to specify the angle and the length for the end point of the bevel.
Manual Bevel
Specifies that the software does not print the bevel in the NC-program. You must do it manually.
Relieve Type
Enables you to add a relief to the bevel. Select a relief type to display the corresponding properties under Relieve Parameters.
N/A
No relief.
U
Adds a relief to the upper side.
L
Adds a relief to the lower side.
B
Adds a relief to both sides.
Relieve Parameters
Length
Specifies the length of the relief.
Angle
Specifies the angle of the relief.
Visualization
Contains commands that enable you to change the bevel icon line and background color.