Click Ellipse
on the toolbar to display the Draw Ellipse properties in the State Manager.
Type
Specifies the parameters you need to enter in the work area to draw the ellipse or elliptical arc. The available types are listed below.
Center Point
Specifies the center point coordinates, two radius values, and an angle. These properties need to be defined so that the software can draw the ellipse.
Axis
Specifies the axis start point coordinates, two radius values, and an angle. These properties need to be defined so that the software can draw the ellipse.
Elliptical Arc
Specifies the axis start point coordinates, two radius values, the angle, the start angle, and the sweep angle. These properties need to be defined so that the software can draw the ellipse.
Parameters
Center point X, Y
Specifies the center point coordinates.
First radius
Specifies the first radius.
Second radius
Specifies the second radius.
Angle
Specifies the angle of the ellipse.
Start angle and End angle
Defines the length of sweep angle. The length of sweep angle defines the length of elliptical arc.