Click Rectangle on the toolbar to display the Draw Rectangle properties in the State Manager.
Type
Contains commands for specifying how you define the element. The selected type determines which parameters are required to define the element. The available types are listed below.
Two Corner Points
Draws a rectangle based on coordinates for one corner point and a defined size.
Center Point And One Corner Point
Draws a rectangle based on the center point coordinates and a defined size.
Three Points
Draws a rectangle based on coordinates for two corner points and a defined width.
Parameters
Corner point X,Y
Specifies the coordinates of a corner point. Depending on the selected drawing Type, the software displays two or three pairs of coordinates. These properties are read-only.
Tool
Specifies how the software interprets the elements when you create cutting paths in the Nesting work area. The following modes are available:
-
Basic Cutting
-
Marking Line
-
Marking Point
-
Painting
-
Ridge
-
Info
-
Marking Text
-
Drilling
Specifies the cutting speed to control the cutting quality.
Specifies whether the software uses the inner profile. The following options are available:
-
Normal
-
NotMirrored
-
Mirrored
Editing a rectangle
Click a rectangle using Select to display the Edit Polyline options (see below) in the State Manager.