Contains commands for controlling views and specifying objects, such as a grid, cut directions, and dimensions to display in the work area. The View bar is shown below (see 4 in Cutting Interface for placement in relation to the work area).
Zoom Fit
Zooms in or out to show the entire part or nesting.
Zoom Area
Zooms into the area you define by dragging a rectangle in the work area location to enlarge.
Zoom Selection
Zooms to the selected objects.
Previous Zoom
Returns to the previous zoom view.
Snap
Displays the Snap to Grid command.
Snap to Grid
Snaps the pointer to the work area grid. This command is available only in the Parts work area.
Show
Displays commands for controlling how objects display in the work area.
The following commands are available in the Parts work area:
Show grid
Displays a grid in the work area.
Show bevel symbols
Displays bevel symbols in the work area.
Show/hide cutting directions
Displays or hides cut directions in the work area.
Show/hide cutting sequence
Displays or hides the cutting sequence in the work area.
Machining mode and attribute popup
Displays tooltips with command information when you point to a geometry element.
Work area text tip
Displays tooltips that contain formation about the active function when you point to a geometry element.
Error, warning, information symbols
Displays error , warning , and information symbols in the work area.
The following commands are available in the Nesting work area:
Cutting Direction
Displays cutting directions in the work area.
Bevel Symbol
Displays bevel symbols in the work area.
Offset Geometry
Displays offset geometry in the work area.
Parts Dimensions
Displays part dimensions in the work area.
Nesting Dimensions
Displays nesting dimensions in the work area.
Error, warning, information symbols
Displays error , warning , and information symbols in the work area.
Info element
Displays dimensions and information lines made in the drawing and nesting work areas.
Torch numbers
Displays torch numbers above nested parts.
Infoboxes
Displays information boxes, such as nesting percentage and coordinates, in the work area.
Amount Errors
Displays error messages in the work area. These error messages indicate that too many parts were nested compared to the amount of ordered parts.
Work area text tip
Displays tooltips that contain formation about the active function when you point to a geometry element.
Bevel Cut Path
Displays the actual bevel cut path on the work area.
The following commands are available on the Show toolbar:
Three Torch Unit
Displays torch locations in the work area. This command is available only when the selected technology group is a bevel gas cutting with three torches.
Offset Geometry
Displays offset geometry in the work area.
Bevel Symbol
Displays bevel symbols in the work area.
Cutting Direction
Displays cutting directions in the work area.
Start Location
Displays the start locations of parts.
Desktop Visual
Displays the Work Area Visual.
Error, warning, information symbols
Displays error , warning , and information symbols in the work area.
Info Tool
Displays the Info Tool, which allows you to inspect part and plate information. Point to a part or a plate to display the information in a tooltip.
Amount Errors
Displays error messages in the work area. These error messages indicate that too many parts were nested compared to the amount of ordered parts.
Info element
Displays dimensions and information lines made in the drawing and nesting work areas.
Torch numbers
Displays torch numbers above nested parts.
Infoboxes
Displays information boxes, such as nesting percentage and coordinates, in the work area.
Work area text tip
Displays tooltips that contain formation about the active function when you point to a geometry element.
Work Area Print
Opens the work area preview, where you can edit an image of the work area and print an unofficial report (see following image). This command is available in the Parts and Nesting work areas.
Work Area Print Editor
Opens the Report Designer, where you edit the report template (see the following image). This command is available in the Parts and Nesting work areas.