-
Click Rectangle on the toolbar to display the Draw Rectangle properties in the State Manager.
-
Click the Type, and then follow the corresponding procedure below. The available types are Two Corner Points , Center Point and one Corner Point , and Three Points .
-
Click Confirm .
By two corner points:
-
Specify the coordinates using the Corner point X,Y boxes.
-
Specify the width and the height.
By the center point and one corner point:
-
Specify the center point coordinates using the Center point X,Y boxes.
-
Specify the width and height.
By three points
-
Specify the coordinates for the first and second corner points using the Corner point X,Y boxes.
-
Specify the width.
To edit a rectangle:
-
Select the rectangle to edit, and use any method below.
-
Click Split polyline under Actions in the State Manager. The software allows you to edit each line of the rectangle.
-
Drag a corner point to reshape the rectangle.
-
Drag a side to resize the rectangle.
-
Press SHIFT and click to add new control points to the rectangle.
-
Press SHIFT and click a control point to remove it.
-