A Rod Hanger support uses the following general attributes:
The above-mentioned Rod Diameter attribute applies to the Constant Spring Rod hanger. This attribute is read-only for the Rigid and Variable Rod Hangers.
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJOAhsBOM_SequenceNo:: SequenceNo |
Specifies the support sequence number. You can use this attribute in a custom BOM definition or leave it blank. |
|
IJUAHgrURS_RodDiameter:: RodDiameter Or IJUAHgrURS_CSRodDiameter:: RodDiameter |
Specifies a numerical value for the rod diameter. This is used to select the correct parts, such as nut and rod for the rod hanger. |
|
IJUAHgrURS_StructureAtt:: StructureAtt |
Specifies the name of the Top sub-assembly that the support uses. |
|
IJUAHgrURS_PipeAtt::PipeAtt |
Specifies the name of the Bottom sub-assembly that the support uses. |
|
IJUAHgrURS_BotRodLen:: BotRodLength |
Specifies the length of the Bottom Rod that is used with a Turnbuckle only. The length is also used for the Bottom Rod length on the Spring Rod Hanger without the Turnbuckle. |