Support Attributes - Intergraph Smart Reference Data Standard Database - Version 12.3 - Help - Hexagon PPM

IJUAhsStanchionOffset::
OffsetFromStructure

Specifies the offset from the supporting structure.

IJUAhsStanchionOffsetRl::OffsetFromStructureRl

Specifies a rule to get the ‘OffsetFromStructure’ value.

If you specify a value, the software gets the ‘OffsetFromStructure’ using rule.

IJUAhsGroutThickness::
GroutThickness

Specifies the thickness of the grout.

If GroutThickness is set to zero or is blank, the software uses the thickness from the grout part.

IJUAhsGroutAngl::
GroutAngle

Specifies the angle between the top and bottom edges of grout.

Any value less than 90 degrees is supported.

IJUAhsAnchorBoltX::
AnchorBoltX

Specifies the offset for anchor bolt X.

Use the following definitions:

1 - Offset from the base plate

2 - Offset between bolts

3 - Offset from the centerline of the base plate

IJUAhsAnchorBoltY::
AnchorBoltY

Specifies the offset for anchor bolt Y.

Use the following definitions:

1 - Offset from the base plate

2 - Offset between bolts

3 - Offset from the centerline of the base plate

IJUAhsAnchorBoltZ::
AnchorBoltZ

Specifies the offset for anchor bolt Z.

If a base plate is not included, the software uses the top of the grout for the measurement.

Use the following definitions:

1 - Distance above plate

2 - Distance from the center of plate to the center of the bolt

IJUAhsStiffenerSup::StiffenerSupport

Specifies the part number or the part class of a stiffener part. The part must be a plate SmartPart.

• Stiffener is mandatory.

• You must specify either a StiffenerPart or a StiffenerRule.

IJUAhsStiffenerSupRl::StiffenerSupportRule

Specifies a rule that returns the part number of the stiffener part.