MemberB Properties - Intergraph Smart Reference Data Standard Database - Version 12.3 - Help - Hexagon PPM

SDB for SRD Hangers and Supports Help 12.3

Language
English
Product
Intergraph Smart Reference Data Standard Database
Search by Category
Help
Smart 3D Version
13
Standard Database for Smart Reference Data Version
12.3

These properties specify and customize the steel back member for member1 in the support.

Refer the above section for properties information. Property names will be like Member1BPart, Member1BRule, Member1BOrientationAngle.

The following OH attributes are applicable for both Member1Part and Member1BPart.

IJUAhsMember1EndOH::Member1EndOverhangValue - Defines the distance at which the main section overhangs past the member. To specify the overhang value using Member1EndOverhangRule, do not type any value for this property.

IJUAhsMember1EndOHRl::Member1EndOverhangRule - Defines an HgrSupportRule that returns the distance at which the main overhangs past the member. The hanger rule name or the ProgID must exist in the catalog. To select the overhang value using Member1EndOverhangValue, do not type any value for this property.

IJUAhsMember1EndOHDef::Member1EndOverhangDefinition - Defines how the EndOverhang is measured. The allowed values areshown below:

IJUAhsMember1EndOHSel::Member1EndOverhangSelection - Uses the hsSelection codelist in the HS_S3DAssy_Codelist.xls workbook to select the Member1EndOverhang by either input or rule. The accepted values are shown below:

By Rule - 1 – Member1EndOverhangRule is used

By Input - 2 – Member1EndOverhangValue is used

IJUAhsCapPlate1::CapPlate1Part - Specifies the part number or the part class for the plate placed at the end of the main section and at the end connected to the member. You must select a Smart-Part 2 Port Plate. To select the part using CapPlate1Rule, do not type any value for this property.

IJUAhsCapPlate1Rl::CapPlate1Rule - Defines an HgrSupportRule that returns a part number or the part class to use for the cap plate. The hanger rule name or the ProgID must exist in the catalog. To specify the part using CapPlate1Part, do not type any value for this property. You can also use CapPlate1Rule to specify a custom part selection rule. If both CapPlate1Part and CapPlate1Rule are specified, then the software considers the CapPlate1Rule as the default part selection rule and overrides the default part selection rule specified in CapPlate1Part.

IJUAhsCapPlate1Ang::CapPlate1Angle - Specifies the angle that CapPlate1 should be rotated about the Z-axis of the port to which the plate is attached.

IJUAhsCapHorOffset::CapHorOffset - Specifies the offset by which the cap plate is moved horizontally.

IJUAhsCapVerOffset::CapVerOffset - Specifies the offset by which the cap plate is moved vertically.