These attributes define the cutback steel properties.
IJOAhsCutback::BeginCutbackAnchorPoint
Specifies the edge for the cutback at the begin face. The codelisted values from the CutbackAnchorPoint sheet in the HS_System_Codelist.xls are 2 - Bottom Center, 4 - Left Center, 6 - Right Center, and 8 - Top Center
IJOAhsCutback::EndCutbackAnchorPoint
Specifies the edge for the cutback at the end face. The codelisted values from the CutbackAnchorPoint sheet in the HS_System_Codelist.xls are 2 - Bottom Center, 4 - Left Center, 6 - Right Center, and 8 - Top Center
IJOAhsCutback:: CutbackBeginAngle
Specifies the start cutback angle for the steel. For CutbackAnchorPoint set to 2 or 8, the face ports rotate by the cutback angle and align along the cutback face.
IJOAhsCutback::CutbackEndAngle
Specifies the end cutback angle for the steel. For CutbackAnchorPoint set to 2 or 8, the face ports rotate by the cutback angle and align along the cutback face.
Angle Value |
Attribute Populated |
Anchor Point |
Result |
---|---|---|---|
+ve |
CutbackBeginAngle |
2 |
Adds specified degrees |
+ve |
CutbackBeginAngle |
4 |
Subtracts specified degrees |
+ve |
CutbackBeginAngle |
6 |
Adds specified degrees |
+ve |
CutbackBeginAngle |
8 |
Subtracts specified degrees |
-ve |
CutbackBeginAngle |
2 |
Subtracts specified degrees |
-ve |
CutbackBeginAngle |
4 |
Adds specified degrees |
-ve |
CutbackBeginAngle |
6 |
Subtracts specified degrees |
-ve |
CutbackBeginAngle |
8 |
Adds specified degrees |
+ve |
CutbackEndAngle |
2 |
Subtracts specified degrees |
+ve |
CutbackEndAngle |
4 |
Adds specified degrees |
+ve |
CutbackEndAngle |
6 |
Subtracts specified degrees |
+ve |
CutbackEndAngle |
8 |
Adds specified degrees |
-ve |
CutbackEndAngle |
2 |
Adds specified degrees |
-ve |
CutbackEndAngle |
4 |
Subtracts specified degrees |
-ve |
CutbackEndAngle |
6 |
Subtracts specified degrees |
-ve |
CutbackEndAngle |
8 |
Adds specified degrees |