These properties specify the Flange and Web modifications when a hanger is snipped by various offset values and angles.
IJOAhsSnipedSteel::CutbackBeginAngle1
Specifies the angle with which the begin face of the flange is snipped.
IJOAhsSnipedSteel::CutbackBeginAngle2
Specifies the angle with which the begin face of the web is snipped.
IJOAhsSnipedSteel::CutbackEndAngle1
Specifies the angle with which the end face of the flange is snipped.
IJOAhsSnipedSteel::CutbackEndAngle2
Specifies the angle with which the end face of the web is snipped.
IJOAhsSnipedSteel::BeginCutbackAnchorPoint1
Specifies the edge for the cutback at the begin face of the flange. The following codelisted values from the CutbackAnchorPoint sheet in the HS_System_Codelist.xls are valid:
-
2 - Bottom Center
-
8 - Top Center. BeginCutbackAnchorPoint1 (read-only value)
IJOAhsSnipedSteel::BeginCutbackAnchorPoint2
Specifies the edge for the cutback at the begin face of the web. The following codelisted values from the hsCutbackAnchorPoint sheet in HS_System_Codelist.xls are valid:
-
4 - Left Center
-
6 - Right Center. BeginCutbackAnchorPoint2 (read-only value)
IJOAhsSnipedSteel::EndCutbackAnchorPoint1
Specifies the plane for the cutback at the end face of the flange. The following codelisted values from the hsCutbackAnchorPoint sheet in HS_System_Codelist.xls are valid:
-
2 - Bottom Center
-
8 - Top Center. EndCutbackAnchorPoint1 (read-only value)
IJOAhsSnipedSteel::EndCutbackAnchorPoint2
Specifies the edge for the cutback at the end face of the web. The following codelisted values from the hsCutbackAnchorPoint sheet in HS_System_Codelist.xls are valid:
-
4 - Left Center
-
6 - Right Center. EndCutbackAnchorPoint2 (read-only value)
IJOAhsCutbackOffset::BeginOffsetAlongFlange
Specifies the offset with which the begin face of the flange is snipped.
IJOAhsCutbackOffset::BeginOffsetAlongWeb
Specifies the offset with which the begin face of the web is snipped.
IJOAhsCutbackOffset::EndOffsetAlongFlange
Specifies the offset with which the end face of the flange is snipped.
IJOAhsCutbackOffset::EndOffsetAlongWeb
Specifies the offset with which the end face of the web is snipped.
IJOAhsFacePortOrient::FacePortOrient
Specifies whether the face port orientation is aligned along the flange, or the web when a snip angle is applied. It is a codelisted value from the hsFacePortOrient sheet in the HS_System_Codelist.xls workbook. Allowed values are: 1 - Face Port Orient Along Flange and 2 - Face Port Orient Along Web.