End1 Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

These properties specify the End1 shape properties for the Strut_A.

IJUAhsRodEnd1::RodEnd1Type

Specifies the graphic shape to be used at End1. The value for this column is a codelist number. Valid codes are listed in the HS_S3DParts_Codelist.xls workbook on the hsRodEndType sheet. Enter the ShortName of codelist for readability in XLS. The nut (female) uses the same graphic shape as the bolt, but the port orientation will be reversed. The port location (red dot) is at z=0.

1 – Plain (Default, no additional graphics)

2 – Eye

3 – Spade

4 – Bolt

5 – Nut (Female)

JUAhsThickness1::Thickness1

Specifies the thickness of the rod end. This value can be negative for Type 4 - Bolt and Type 5 - Nut.

1 – Plain (no effect on graphics)

2 – Eye

3 – Spade

4 – Bolt

5 – Nut (Female)

IJUAhsLength1::Length1

Specifies the length from the base of the spade to the port location, which is also the start of the curved end. Only zero or positive values are allowed. This property is valid for spade end type only.

IJUAhsDiameter1::Diameter1

Specifies the outside diameter of the rod ends.

1 – Plain (no effect on graphics)

2 – Eye

3 – Spade

4 – Bolt

5 – Nut (Female)

IJUAhsGap1::Gap1

Specifies a double-spade end or a single-spade end. If this value is zero, then a single-spade is drawn. If this value is a positive number, then a double-spade is drawn with two identical spades separated by the gap value defined here.

IJOAhsAngle1::Angle1

Specifies the rotation angle about the longitudinal axis for the rod end, Shape 1, and the port.