Library Name: SmartParts
Workbook: HS_S3DParts.xls
Codelist: HS_S3DParts_Codelist.xls
ProgID: HSSmartPart,Ingr.SP3D.Content.Support.Symbols.Pin
Part Name: Pin
Part Description: Pin SmartPart
To place a sample Pin SmartPart delivered with the catalog:
-
Click Tasks > Hanger and Supports.
-
Place a design support on a pipe.
-
Click Place Part , and then select the design support.
-
In the Select Part dialog box, select a part from Parts > SmartParts > S3D Standard > Miscellaneous > Pins > Pin with Cotter Pins as shown in the following example:
Part Properties
Millimeters (mm) is the default unit. Use "in" at the end of dimensional values to specify inches. Ports are shown as points highlighted in red.
Local Coordinate System
These properties define the geometry of the Pin.
IJUAhsPin1::Pin1Diameter
Specifies the diameter of the Pin. This value cannot be set to 0.
IJUAhsPin1::Pin1Length
Specifies the length of the Pin. This value cannot be set to 0.