These properties specify the plate properties for the block clamp.
IJUAhsThickness1::Thickness1
Specifies the thickness of the top plate. If this value is set to zero, the top plate is not shown.
IJUAhsLength1::Length1
Specifies the length of the top plate.
IJUAhsWidth1::Width1
Specifies the width of the top plate.
IJUAhsThickness2::Thickness2
Specifies the thickness of the bottom plate. If this value is set to zero, the bottom plate is not shown.
IJUAhsLength2::Length2
Specifies the length of the bottom plate.
IJUAhsWidth2::Width2
Specifies the width of the bottom plate.
IJUAhsMidPlateBotShape::MidPlateBotShape
Specifies the name of the middle bottom plate shape. If more than two pipes are supported, the pipe holes or dents are not shown.
The following middle bottom shapes are supported:
IJUAhsMidPlateTopShape::MidPlateTopShape
Specifies the name of the middle top plate shape. If more than two pipes are supported, the pipe holes or dents are not shown.
The following middle top shapes are supported:
IJUAhsThickness3::Thickness3
Specifies the thickness of the base plate. If this value is set to zero or not provided, the base plate is not shown.
IJUAhsLength3::Length3
Specifies the length of the base plate.
IJUAhsWidth3::Width3
Specifies the width of the base plate.
IJUAhsThickness4::Thickness4
Specifies the thickness of the vertical plate or stanchion. Thickness4 must be greater than zero, or the vertical plate or stanchion is not shown.
IJUAhsLength4::Length4
Specifies the length of the vertical plate. If Length4 is set to zero, a stanchion is drawn instead of a vertical plate.
IJUAhsWidth4::Width4
Specifies the width of the vertical plate. If Length4 is set to zero, Width4 specifies the diameter of the stanchion.
IJUAhsThickness5::Thickness5
Specifies the thickness of channel clips. Channel clips are only shown when Thickness5 is greater than zero.
IJUAhsLength5::Length5
Specifies the length of channel clips.
IJUAhsWidth5::Width5
Specifies the width of channel clips.
IJUAhsWidth6::Width6
Specifies the distance between channel clips.
IJUAhsPin1::Pin1Length
Specifies the length of the bolt. Pin1Diameter and Pin1Length must be greater than zero for the bolts to be shown.
IJUAhsPin1::Pin1Diameter
Specifies the diameter of the bolt. Pin1Diameter and Pin1Length must be greater than zero for the bolts to be shown.
IJUAhsHeight1::Height1
Specifies the distance from the pipe centerline of the first pipe to the top of the block clamp.
IJUAhsHeight2::Height2
Specifies the distance from the pipe centerline of the first pipe to the bottom of the block clamp.
IJUAhsOffset1::Offset1
Specifies the lateral offset of block clamp if it is not centered on the pipe. If there is more than one pipe, Offset1 specifies the distance between the pipes.
IJUAhsOffset2::Offset2
Specifies the lateral distance from the center of the pipe to the edge of the block. Offset2 is used if there is only one pipe and Offset1 is set to zero.
IJUAhsOffset3::Offset3
Specifies the distance between blocks. Offset3 is used only if there are two blocks. If Offset3 is less than the block Width, then only one block is shown. Also, if Offset3 is greater than or equal to the block Width, then two blocks are shown.