The following properties are used to set the dimensions and location of the nut used in the beam clip.
JUAhsShape1::Shape1Type
Specifies the graphic shape used for the nut or washer. This value uses the codelist number defined in the hsShapeType sheet of the HS_S3DParts_Codelist.xls workbook.
IJUAhsShape1::Shap1Width1
Specifies the outside dimension of the nut or washer.
IJUAhsShape1::Shape1Width2
Specifies the other outside dimension of the nut or washer.
IJUAhsShape1::Shape1Length
Specifies the length of the nut or washer.