Bottom Shape Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

These properties define the geometry of the bottom shape of the beam clamp.

IJUAhsThickness1::Thickness1

Specifies the thickness of the bottom shape.

IJUAhsWidth1::Width1

Specifies the width of the bottom shape.

IJUAhsHeight1::Height1

Specifies the first height of the bottom shape. For shape I, this property will be ignored.

IJUAhsHeight2::Height2

Specifies the second height of the bottom shape. For shape I and shape C, this property will be ignored.

IJUAhsLength1::Length1

Specifies the first length of the bottom shape.

IJUAhsLength2::Length2

Specifies the second length of the bottom shape. For shape I and shape U, this property will be ignored.

IJUAhsRodTakeOut::RodTakeOut

Specifies the distance between the structure port and the RodEnd port. If no value is set to RodTakeOut, then, both, the structure port and the RodEnd port will be aligned on the same horizontal line.

RodEnd port is created only if BottomShape is assigned a defined value.

IJUAhsAngle1::Angle1

Specifies the angle between the structure and the bottom shape. Both, positive and negative values are allowed. It is required only for sloped steel configuration.

This property is applicable only for U shape bottom type.