These properties define the geometry of the bolt.
IJUAhsPin1::Pin1Diameter
Specifies the diameter of the bolt. If this value is less than or equal to zero, then the software sets RodDiameter as the default value.
IJUAhsPin1::Pin1Length
Specifies the length of the bolt. If this value is less than or equal to zero, then the software sets 1.25 * (Diameter1 + 2 * Thickness1 + 2 * Thickness2) as the default value.
IJUAhsHeight2::Height2
Specifies the height of the bolt from the pipe centerline to the centerline of the bolt. If this value is less than or equal to zero, then the software sets RodTakeOut - 1.5 * Pin1Diameter as the default value. If ClevisBotShp = 3, then the software interprets this value as a negative distance from the pipe centerline. If this value is less than or equal to zero and ClevisBotShp = 3, then the software sets 0.75 * Diameter1 as the default value.
-
ClevisBotShp ยน 3
-
ClevisBotShp = 3