IJUAhsCC::CC
Specifies the distance between the centerlines of the rods connected to a type G spring.
IJUAhsLoad::Load
Specifies the actual load supported by the constant support.
IJUAhsMovement::Movement
Specifies the amount of thermal displacement of the pipe when moving from the installed (cold) to operating (hot) conditions.
IJUAhsMovementDir::MovementDirection
Specifies the direction of the displacement when moving from the installed to operating conditions. It uses codelist value defined in the hsSpringMovementDir sheet of the HS_S3DParts_Codelist.xls workbook.
IJUAhsTTIncrement::TTIncrement
Specifies the increments between total travels. For example, if total travel goes up in ½ inch increments, set this value to 0.5.
IJUAhsTTIncrementByRule::TTIncrementByRule
Specifies the rule that the software uses to get the total travel increment value. The total travel increment value from the TTIncrementByRule overrides TTIncrement value.
IJUAhsTTUnitType::TTUnitType
Specifies the units of the total travel.
IJUAhsValidTravels::ValidTravelList
Specifies the name of a codelist table that lists all the valid total travel values for the constant support. If you specify a codelist table, then the software selects the total travel value from the list instead of using TTIncrement. Use this for vendors with Total Travel values that do not increase by a consistent value.
Store the total travel as a numeric value in the ShortDescription column of the codelist table.
IJUAhsOverTravelMin::OverTravelMin
Specifies the minimal amount that the total travel must exceed the movement/actual travel.
IJUAhsOverTravelPercent::OverTravelPercent
Specifies the percentage amount that the total travel should be greater than the movement.