These properties are used to set the external bolt on the right clip.
IJUAHsRightClipBolt::BoltLength2
Specifies the length of the bolt used in the beam clamp for right beam clip. If this value is less than or equal to zero, no bolt is drawn.
IJUAHsRightClipBolt::BoltDiameter2
Specifies the diameter of the bolt used in the beam clamp for right beam clip. If this value is less than or equal to zero, no bolt is drawn.
IJUAHsRightClipBolt::HeadType2
Specifies the shape of the bolt's head. Allowed values are:
If this value is either zero or not specified, then no bolt head is modeled.
IJUAHsRightClipBolt::HeadThickness2
Specifies the thickness of the bolt head. If this value is less than or equal to zero, no bolt is drawn.
IJUAHsRightClipBolt::HeadWidth2
Specifies the width of the bolt head. If this value is less than or equal to zero, no bolt is drawn.