Rounded Notch Corner (Concave) - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

IJUAhsTLCorner1::TLCornerType1

Specifies the corner type for the rounded notch. See the hsCornerShape sheet from the HS_S3DParts_Codelist.xls workbook for all the valid codes. Use codelist value 6 for this corner type.

IJUAhsTLCorner1::TLCornerX1

Specifies the horizontal offset of the round notch center point. You can not offset the round notch off the plate in either direction. For both corners to be rounded as shown below, set the value to less than half of Width1.

If the TLCornerX1 value is set to zero then, the notch center is aligned with the top-left corner point and the notch shape is a quarter circle arc.

X = 0, Zero Offset

If the TLCornerX1 value is set to a positive value then, the software moves the center point into the plate horizontally and adds a flat landing to the quarter-circle arc.

X > 0, Positive Offset

If the TLCornerX1 value is set to a negative value then, the software moves the center point away from the plate horizontally. This reduces the sweep angle of the notch shape and is less than a quarter-circle.

X < 0, Negative Offset

IJUAhsTLCorner1::TLCornerY1

Specifies the vertical offset of the round notch center point. You can not offset the round notch off the plate in either direction. If the TLCornerY1 value is set to zero then, the notch center is aligned with the top-left corner point and the notch shape is a quarter circle arc.

Y = 0, Zero Offset

If the TLCornerY1 value is set to a positive value then, the software moves the center point into the plate vertically and adds a flat landing to the quarter-circle arc.

Y > 0, Positive Offset

If the TLCornerY1 value is set to a negative value then, the software moves the center point away from the plate vertically. This reduces the sweep angle of the notch shape and is less than a quarter-circle.

Y < 0, Negative Offset

IJUAhsTLCorner1::TLCornerRadius1

Specifies the radius of the round notch shape.

If you require space in the X direction, the TLCornerRadius1 value must be greater than zero and less than Width1 value.

If you require space in the Y direction, the TLCornerRadius1 value must be greater than zero and less than Length1 value.

If the TLCornerRadius1 value is set to zero, the software creates a sharp corner edge.