IJUAhsSmartShapeType::SmartShapeType
Specifies the classification of the shape. This property uses the codelist number defined in the hsSmartShapeType sheet in the HS_S3DParts_Codelist.xls workbook.
IJUAhsOpening1::Opening1
Specifies the inside distance between the two units. This value can be zero.
IJUAhsShape1::Shape1Type
Specifies the codelist number of the shape type as defined in the hsShapeType sheet in the HS_S3DParts_Codelist.xls workbook.
In each of the following examples, the end nut shape is drawn with hatched lines.
1 - Round
2 - Square
3 - Hex
IJUAhsShape1::Shape1Width1
Specifies the outside dimension of the end nuts. If this value is zero, the end nut shape is not displayed.
1 - Round
2 - Square
3 - Hex
IJUAhsShape1::Shape1Width2
Specifies the outside length of the end nut shapes. If this value is zero, the value specified in Shape1Width1 is used. This value is not used for the hex shape.
1 - Round
2 - Square
IJUAhsShape1::Shape1Length
Specifies the thickness of the end nut shape. If the value is negative, the end nut shapes are located within Opening1. If this value is set to zero, the end nut shape is not displayed.
Shape1Length < 0 (Negative)
Shape1Length > 0 (Positive)
IJUAhsLength2::Length2
Specifies the length of the side blocks. If this value is zero, the side blocks are not displayed.
IJUAhsWidth2::Width2
Specifies the width of the side blocks. If this value is zero, the side blocks are not displayed.
IJUAhsThickness2::Thickness2
Specifies the thickness of the side blocks. If this value is zero, the side blocks are not displayed.
IJUAhsOpening2::Opening2
Specifies the opening between the two side blocks. Ignore this value to prevent blocks from being displayed.
IJUAhsDiameter1::Diameter1
This value is optional. Specifies the diameter of the round center tube. This property is normally used for a turnbuckle without side blocks, but it can be used for either. The tube is modeled with the same length as the Opening1 value and is fitted between the two nut end shapes. If this value is zero, the center tube is not displayed.