Washer Plate Attributes - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

1 - Port2:RodEnd2
2 - Bolt Head
3 - Top Washer Plates
4 - Rod
5 - Bottom Washer Plates
6 - Nut
7 - Port1:RodEnd1

IJUAhsWPlateShape::Shape3Type

Specifies the attributes for the washer plate shape types. This property uses the following hsShapeType codelist values:

1 - Round

2 - Square

3 - Hex

IJUAhsWPlateShape::Shape3Width1

Specifies the outer dimension of the washer plate shape. This property uses the following codelist values:

1 - Round

2 - Square

3 - Hex

IJUAhsWPlateShape::Shape3Width2

Specifies the outer dimension of the washer plate shape. This property uses the following codelist values:

1 - Round

2 - Square

3 - Hex

IJUAhsThickness3::Thickness3

Specifies the thickness of the washer plate.

IJUAhsTWPlateCount::TWPlateCount

Specifies the number of washer plates above the plate or the existing steel.

IJUAhsBWPlateCount::BWPlateCount

Specifies the number of washer plates below the plate or the existing steel.

IJOAhsGap1::Gap1

Specifies the gap between the top and the bottom washer plates. The top washer plate is always attached to the bottom of the bolt head. The bottom washer plate is always attached to the top of the nut (if a nut exists).

If no washer plates exist, the gap is calculated as the offset value between the bolt head and the nut. You can set this value using CSD.