These properties specify the general properties for the WBA Hole that are used for the part selection, WBA Hole configuration, and the port location.
IJUAhsRodDiameter::RodDiameter
Enter the outside diameter of rod fittings that attach to the welded beam attachment. This value is used for part selection rules for choosing a right welded-beam attachment part and is not used for creating graphics.
IJUAhsSize::Size
Enter the size to be used for the part selection rule that is not using the RodDiameter. For example, C&P parts are based on size, not diameter. This value is not used for creating graphics.
IJUAhsWBAHoleConfig::WBAHoleConfig
This codelisted value specifies whether the part is made from one continuous shape or by separate plates. The value for this column is a codelist number, and valid codes are listed in the HS_S3DParts_Codelist.xls workbook in the hsWBAHoleConfig sheet. The continuous option does not include the rod attachment. If a base plate is added when continuous is being used, the base plate is not part of the continuous graphic. It is a separate plate on top of the continuous graphic. The flat spot of the WBA is 90% of Gap1.
1 = Continuous
2 = Plates
IJUAhsOffset1::Offset1
Enter the vertical offset of the hole port from the lowest edge of the WBA (Height1). If this value is set to zero, the hole port is flush with the lowest edge of the WBA. Only positive values are acceptable.
