The Offset 1 attributes define the span or the offset for the main steel member from the route. The Hold Down support uses the following attributes:
Name |
User Name |
Category |
On Property Page |
Read Only |
---|---|---|---|---|
Offset1Value |
Offset 1 |
Dimensions |
Yes |
No |
Offset1Rule |
Offset 1 - Rule |
Dimensions |
No |
Yes |
Offset1Definition |
Offset 1 - Definition |
Dimensions |
No |
Yes |
Offset1Selection |
Offset 1 - Selection |
Dimensions |
Yes |
No |
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsFrameOffset1:: |
Specifies the value for Offset 1. |
The following definitions are supported: 1 - Route Center to Center to Member 1 Edge 2 - Route Edge to Leg Edge 3 - Route Center to Bolt Edge 4 - Route Edge to Bolt Edge For Offset1Definition, the offset does not include the overlength of member 1. |
Offset 2 Attributes
Offset 2 attributes display the same behavior as Offset 1 attributes.