Reviews and modifies turn features or components.
Properties
Opens a dialog box with properties for the selected feature. Allows you to review the properties of the selected feature and change the value assigned to a property.
Move From
Defines the origin of the move vector. If you do not define a starting point, the current location of the turn is assumed to be the starting point.
Move To
Defines the termination point of the move vector.
Plane
Plan Plane
Defines the work surface as the XY plane at the depth of the active end. You also can press CTRL+1 to select this option.
Elevation Plane: East-West ( Z Plane: X-Axis)
Defines the work surface as the XZ plane. You also can press CTRL+2 to select this option.
Elevation Plane: North-South ( Z Plane: Y-Axis)
Defines the work surface as the YZ plane. You also can press CTRL+3 to select this option.
Plane by Turn/Branch
Defines the work surface as the plane defined by an existing turn or branch. You select the turn or branch to set the plane. You also can press CTRL+4 to select this option.
Plane by Three Points
Defines the work surface using three points that you define. You also can press CTRL+5 to select this option.
No Plane
Clears any work surfaces. The software does not project points that you place to any plane. You also can press CTRL+6 to select this option.
Run
Defines the name of the duct run associated with the turn.
Part
Defines the part of the turn feature. The part that you select determines the other controls that display on the ribbon.
Lock
Turns on or off locking for the angle. If the angle is locked, then you cannot change the value. There are Lock buttons for Angle2 and Angle3, but not for Angle1.
Angle1
Defines the angle of the selected turn feature.
Angle2 / Angle3
Defines the angle of the turn or branch feature located at the end of associated leg.
Miters
Defines the number of miters for the turn feature.
Offset
Defines the distance for offset that the software uses during feature placement. The reference is centerline, width, or depth). The route plane need not be active to locate the offset from the plane point.