-
On the Route Duct Ribbon, click Working Plane
.
-
Select the working surface for the duct run.
Available options for the working plane include:
Plan Plane
Defines the work surface as the XY plane at the depth of the active end. You also can press CTRL+1 to select this option.
Elevation Plane: East-West (
Z Plane: X-Axis)
Defines the work surface as the XZ plane. You also can press CTRL+2 to select this option.
Elevation Plane: North-South (
Z Plane: Y-Axis)
Defines the work surface as the YZ plane. You also can press CTRL+3 to select this option.
Plane by Turn/Branch
Defines the work surface as the plane defined by an existing turn or branch. You select the turn or branch to set the plane. You also can press CTRL+4 to select this option.
Plane by Three Points
Defines the work surface using three points that you define. You also can press CTRL+5 to select this option.
No Plane
Clears any work surfaces. The software does not project points that you place to any plane. You also can press CTRL+6 to select this option.