Controls parameters for adding a regional margin.
Properties
Activates the Regional Margin Properties Dialog, which you use to view and modify the settings for the regional margin you have selected.
Select Part
Select the object on which to place the margins. The object can be a plate, profile, or member, depending on the setting in the Part Filter box. This option is not available during modification.
Select Edge
Select the edge of the object on which to place the margins. This option is not available during modification.
Select Edge Segment
Select the edge segment upon which to place the regional margin. This option is only available for profiles and members.
Select Start Point
Select the start point of the margin. This can be either of the two end points of the edge segment.
Select End Point
Select the end point of the margin.
Finish
Creates or modifies the regional margin.
Cancel
Clears the selection.
Accept
Accepts the selection.
Part Filter
Indicates which object can be selected. Available options include:
-
Plate
-
Profile
-
Member
Rule
Indicates whether the margin is created by rule.
Mode
Specifies the mode of margin to apply. You cannot change the mode of an existing margin. Available options include:
-
Constant
-
Oblique
Type
Specifies the type of margin to apply. Available options include:
-
Heating
-
Bending
-
Intercostal
-
Coaming
-
End Face
-
Non-trimmed
-
Trimmed
Start Value
Specifies the amount of margin to apply. If Mode is set to Constant, this is the margin value. If Mode is set to Oblique, this is the margin value applied to the start end.
End Value
Specifies the amount of margin to apply to the end point when Mode is set to Oblique.
Add
Creates a new margin, or updates the selected margin. The new margin highlights in white.
Delete
Deletes the selected margin. This option is only available when you select one of the margins in the Show Form dialog.
Form
Indicates whether to display a dialog containing all of the margins that have been placed. All of the margins in this dialog are created when you click Finish. Select a row to display the corresponding margin values in the ribbon bar. When you select a margin on the dialog , the corresponding margin highlights in the model.