Where applicable, each AText description includes its respective default value. If a default value is not specified, the AText is normally left blank.
For each AText, three options are available:
-
<Default> uses the default AText value.
-
<Suppress> suppresses the AText value.
-
<Edit value> modifies the AText value with the user-specified entry.
The reference plane ATexts output the relative directions associated with reference planes. Where applicable, substitute the ^ character with the reference plane name. Substitute the ? character with the distance from the reference plane.
Sub Volume Label
Controls the output of sub-volume names at coordinate positions on the isometric drawing. The default value is VOL ?.
AText ID: |
-398 |
? Value: |
Sub-volume name |
$ Supported: |
Yes |
X Relative Coordinate
Identifies the positive relative position in the E/W plane. The default value is ^+?.
AText ID: |
-443 |
? Value: |
Ref Plane/Coord |
$ Supported: |
Yes |
-X Relative Coordinate
Identifies the negative relation position in the E/W plane. The default value is ^+?.
AText ID: |
-444 |
? Value: |
Ref Plane/Coord |
$ Supported: |
Yes |
Y Relative Coordinate
Identifies the positive relative position in the N/S plane. The default value is ^+?.
AText ID: |
-445 |
? Value: |
Ref Plane/Coord |
$ Supported: |
Yes |
-Y Relative Coordinate
Identifies the negative relative position in the N/S plane. The default value is ^+?.
AText ID: |
-446 |
? Value: |
Ref Plane/Coord |
$ Supported: |
Yes |
Z Relative Coordinate
Identifies the positive relative position in the U/D plane. The default value is ^+?.
AText ID: |
-447 |
? Value: |
Ref Plane/Coord |
$ Supported: |
Yes |
-Z Relative Coordinate
Identifies the negative relative position in the U/D plane. The default value is ^+?.
AText ID: |
-448 |
? Value: |
Ref Plane/Coord |
$ Supported: |
Yes |
Reference Plane Delimiter
An AText record has been assigned to be output as a delimiter between the relative direction and its relative position. AText set to blank only outputs the relative position. The default value is ^+?.
AText ID: |
-449 |
? Value: |
None |
$ Supported: |
No |
Location Point Label
Indicates a location point position on the plotted isometric drawing. If more than one is included on any single isometric, a simple ID number is generated and output in the position indicated by the ? character. The default value is LOCATION-POINT?.
AText ID: |
-471 |
? Value: |
|
$ Supported: |
Yes |
Location Point Identifier
Outputs a location point ID number on the drawing frame. It is only output when multiple location points are included on a single isometric drawing. The default value is No.?.
AText ID: |
-472 |
? Value: |
Location Point ID |
$ Supported: |
Yes |
Location Point of Label
Used as part of a location point position on the drawing frame. The default value is OF.
AText ID: |
-473 |
? Value: |
None |
$ Supported: |
No |
Location Point Above Label
Used as part of a location point position on the drawing frame. The default value is ABOVE.
AText ID: |
-474 |
? Value: |
None |
$ Supported: |
No |