Sets the values of text strings on isometric drawings.
Smart 3D Alternative Texts
Provides options for defining user-specified text strings that are output on the isometric drawing.
Open the grid, and then define the attributes listed below as needed.
-
TextPurpose provides a value corresponding to the text to replace. The values provided are Smart 3D-specific. The table below lists the Intergraph Alternative Text options that are currently supported by the software.
|
DEG_DEFAULT defines the text output on the drawing to denote degrees. |
|
|
HOR_DEFAULT denotes the horizontal orientation angle. |
|
|
IN_LENGTH_DEFAULT defines the text output on the drawing to denote length in inches. |
|
|
MM_DEFAULT defines the text output on the drawing to denote unit measurement in millimeters. |
|
|
NO_SPOOL_DEFAULT defines the text output on the drawing if there are no spools in the drawing. |
|
|
ORIENT_HANDLE_DEFAULT defines the text output on the drawing |
|
|
UNDEFINED_INSULATION_SPEC_DEFAULT defines the text output on the drawing to denote the insulation specification is undefined for a feature or a run. |
|
|
UNDEFINED_PAINT_SPEC_DEFAULT defines the text output on the drawing to denote the painting specification is undefined for a feature or a run. |
|
|
UNDEFINED_TRACING_SPEC_DEFAULT defines the text output on the drawing to denote the tracing specification is undefined for a feature or a run. |
|
|
VOR_DEFAULT denotes the vertical orientation angle. |
|
|
The following AText options generate abbreviate direction strings, such as 35 N 45 E. Used when the orientation is non-orthogonal.
These AText options generate full text direction strings (such as EAST or SOUTH). Used when the orientation is orthogonal.
|
To override all direction settings, you must define the Smart 3D AText option and
the Isogen AText option
Defines:
Option Switch - N/A
I-Configure - S3D.IntergraphAlternativeTexts