Member Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports Data Driven Assembly Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

Use these properties to specify and customize the main steel member in the support.

IJUAhsMember1::Member1Part

Specifies the steel part number for the main support section. The part number must be a rich hanger beam. To select the part number using Member1Rule, do not type any value for this property.

IJUAhsMember1Rl::Member1Rule

Defines an HgrSupportRule that returns a rich hanger beam part number. The hanger rule name or the ProgID must exist. To select a part number using Member1Part, do not type any value for this property.

IJUAhsMember1Ang::Member1OrientationAngle

Specifies the angle of rotation for the main member. The angle is about the member's axis. The allowed values are as shown below:

IJUAhsMember1EndOH::Member1EndOverhangValue

Defines the distance at which the main section overhangs past the member. To specify the overhang value using Member1EndOverhangRule, do not type any value for this property.

IJUAhsMember1EndOHRl::Member1EndOverhangRule

Defines an HgrSupportRule that returns the distance at which the main overhangs past the member. The hanger rule name or the ProgID must exist in the catalog. To select the overhang value using Member1EndOverhangValue, do not type any value for this property.

IJUAhsMember1EndOHDef::Member1EndOverhangDefinition

Defines how the EndOverhang is measured. The allowed values are as shown below:

IJUAhsMember1EndOHSel::Member1EndOverhangSelection

Uses the hsSelection codelist in the HS_S3DAssy_Codelist.xls workbook to select the Member1EndOverhang by either input or rule. The accepted values are as shown below:

  • By Rule - 1 – Member1EndOverhangRule is used

  • By Input - 2 – Member1EndOverhangValue is used

IJUAhsCapPlate1::CapPlate1Part

Specifies the part number or the part class for the plate placed at the end of the main section and at the end connected to the member. You must select a Smart-Part 2 Port Plate. To select the part using CapPlate1Rule, do not type any value for this property.

IJUAhsCapPlate1Rl::CapPlate1Rule

Defines an HgrSupportRule that returns a part number or the part class to use for the cap plate. The hanger rule name or the ProgID must exist in the catalog. To specify the part using CapPlate1Part, do not type any value for this property. You can also use CapPlate1Rule to specify a custom part selection rule. If both CapPlate1Part and CapPlate1Rule are specified, then the software considers the CapPlate1Rule as the default part selection rule and overrides the default part selection rule specified in CapPlate1Part.

IJUAhsCapPlate1Ang::CapPlate1Angle

Specifies the angle that CapPlate1 should be rotated about the Z-axis of the port to which the plate is attached.

IJUAhsCapHorOffset::CapHorOffset

Specifies the offset by which the cap plate is moved horizontally.

IJUAhsCapVerOffset::CapVerOffset

Specifies the offset by which the cap plate is moved vertically.