Move Continuously - Intergraph Smart Review - Help

Intergraph Smart Review Help

Language
English
Product
Intergraph Smart Review
Search by Category
Help
SmartPlant Foundation / SDx Version
10
Smart Review Version
2020 (15.0)

Motion > Move > Continuous

Moves the eye point or display set through the model at a constant rate and in a constant direction, using the keypad to steer. Motion continues even if you provide no input. When Continuous Step is off, you move through the model only by command from the mouse, keypad, or joystick. Continuous motion mode also allows you to use other commands while in motion.

  1. Click Motion > Move > Continuous.

  2. Click in the model.

  • In continuous motion, you move through the model at a constant rate and in a constant direction, using the keypad to steer. Motion continues even if you provide no input.

  • You can also click Continuous on the View toolbar or press 0 on the keypad to start Continuous motion.

  • If you press 0 on your keypad to start Continuous motion, the last keypad motion command is repeated up to the rate specified by Maximum moves per second on the Motion Settings > Rates tab. For example, if you press 5 on the keypad for Toggle Step Direction and then press 0, Continuous will repeat the Toggle Step Direction motions.

  • Press Esc or 0 on the keypad to stop the motion.

  • Continuous motion reverses direction after you complete a single step, select Continuous, and then toggle the step direction. However, Continuous motion does not reverse direction if the last keypad motion before you toggled the step direction was not a step.

See Also

Set Step Direction