Add a New Instrument to the Existing Wiring - Intergraph Smart Instrumentation - Training - Intergraph Process, Power & Marine Documentation

SmartPlant InstrumentationTutorial

Language
English
Product
Intergraph Smart Instrumentation
Search by Category
Training
Smart Instrumentation Version
2016 SP1 (11.0.1)
Smart Instrumentation Web Version
(none)
  1. In the Domain Explorer, expand the Panels by Category > Junction Boxes hierarchy and then select junction box 101-JB-DCS-001.

  2. Right-click the selected junction box and then on the shortcut menu, click
    Actions > Connection.

  3. Make sure that terminal strip 101-JB-DCS-001, TS-1 is selected in the Terminal strip list (there is only one terminal strip on the list).

  4. In the Cables folder of Domain Explorer, select cable C-101-LT-201 and drag it to the right side of terminal 6.

  5. On the Cable Connection Definition dialog box, make your selections as follows:

    1. Under Cable end to connect, select End 2.

    2. Select the connection type as 3 in a row and select the cable set in the right data window.

  6. Click Connect to make the connection.

  7. After the cable has been connected, open the Point-to-Point Wiring Diagram for the wire connected to terminal 6+ and view the connection. It should go straight to terminal strip FT-1 of the marshaling rack.

  8. Print out the Point-to-Point Wiring Diagram if needed and then click X to close it.

  9. Click X to close the Connection window.

  10. Now select 101-DCS-001 from the DCS Panels folder in the Domain Explorer.

  11. Right-click the selected panel, then on the shortcut menu, click Actions > I/O Assignment.

  12. On the module toolbar, click to open the I/O Assignment Filter dialog box.

  13. Select the first three filtering criteria and click OK.

  14. In the I/O Assignment window, select tag 101-LT -201 and drag it to channel 3 in the right side pane.

  15. On the Control System Tag Properties dialog box, type BLI 201 and click OK.

  16. Now close the I/O Assignment window and select marshaling rack 101-MR-DCS-001.

  17. Right-click the selected panel, then on the shortcut menu, click Actions > Connection.

  18. In the Terminal strip list, select 101-MR-DCS-001, TP-1.

    Note that your tag wiring has been propagated from the DCS to the marshaling rack terminals.

  19. Close the Connection window.

  20. Right-click the same marshaling rack again, then on the shortcut menu, click Actions > Cross Wiring.

  21. Click to find matching terminals for automatic cross wiring.

    The software finds matching terminals for automatic cross-wiring. You can view them by scrolling down in the Primary Terminal Strip pane:

  22. Click to perform the automatic cross wiring.

  23. Close the Cross Wiring window.

You have successfully added a new tag to your wiring.