These properties define the u-bolt portion of the yoke clamp.
IJUAhsUBolt::UBoltWidth
Specifies the center to center distance between the legs of the u-bolt.
This value is always greater than UBoltRodDia. This value determines the spacing of the vertical legs of the u-bolt as well as the bend radius for the curved part of the u-bolt. The nominal bend radius is equal to half the UBoltWidth dimension.
IJUAhsUBolt::UBoltCenterToEnd
Specifies the distance from the pipe centerline to the end of the u-bolt legs.
IJUAhsUBolt::UBoltRodDia
Specifies the diameter of the round stock used to make the u-bolt.
If this value is set to zero none of the u-bolt shape is drawn unless the UBoltDia2 is non-zero.
IJUAhsUBolt::UBoltDia2
Represents a diameter change for round insulation, coatings, or to delete the curved part of the u-bolt.
If this value is greater than 0, the software changes the diameter of the curved part of the u-bolt starting at the position UBoltDia2Start as shown in Fig.1.
This value can be larger or smaller than UBoltRodDia. If it is equal to 0, it defaults to the same diameter as UBoltRodDia. If it is less than 0, then the curved part of the u-bolt is not visible in the graphics starting at the UBoltDia2Start as shown in Fig. 2.
IJUAhsUBolt::UBoltDia2Start
Specifies the start position of a diameter change. This value is used to represent round insulation, coatings, or to delete the curved part of the u-bolt.
If UBoltDia2 is zero or the same value as UBoltRodDia, this has no effect because there is no change in the rod diameter.
IJUAhsUBolt::UBoltFlatSpot
If UBoltDia2 is negative this is ignored because, there is no curved part of the u-bolt to have a flat spot.
This value also adds a flat spot to the shape of the rectangular wrap or strap.
If it is set to zero, no flat spot is shown in the curved part of the u-bolt. If it is set to a positive value, a flat spot is shown in the curved section of the u-bolt. This also reduces the bend radius and center points for the curved part of the u-bolt.
This value is always less than BoltCenters1 - UBoltRodDia.
IJUAhsUBolt::UBoltTopGap
Specifies the gap between the outside of the pipe and the inside of the u-bolt (the gap is based on UBoltRodDia. It is not based on UBoltDia2).
This value affects the vertical position of the center of the bend radius for the curved portion of the u-bolt.
IJUAhsUBolt::UBoltOneSided
This property is not applicable to yoke clamp.