The following properties define the basic geometry of the optional gusset.
IJUAhsWidth5::Width5
Specifies the primary width of the gusset. This value must be greater than zero, or no gussets are modeled.
IJUAhsLength5::Length5
Specifies the primary length of the gusset. This value must be greater than zero, or no gussets are modeled.
IJUAhsThickness5::Thickness5
Specifies the primary thickness of the gusset. This value must be greater than zero, or no gussets are modeled.
IJUAhsWidth6::Width6
Specifies the secondary width of the gusset. This value must be greater than or equal to zero.
IJUAhsLength6::Length6
Specifies the secondary width of the gusset. This value must be greater than or equal to zero.
IJUAhsOffset3::Offset3
Specifies the horizontal position of the gusset's corner.
IJUAhsOffset4::Offset4
Specifies the vertical position of the gusset's corner.
IJUAhsMulti1::Multi1Qty
Specifies the quantity of gussets on each side. Gussets are not shown when Multi1Qty is set to zero.
IJUAhsMulti1::Multi1LocateBy
Specifies the location of the bolts. Each bolt can be located in two ways.
1 - Relative to center of the group
2 - Relative to edge.
The exact meaning depends on the quantity of bolts. This value can be 0 (nothing), 1 (center), or 2 (Edge).
IJUAhsMulti1::Multi1Location
Specifies the distance for the exact location of the gussets depending on Multi1LocateBy and Multi1Qty. This value can be either a distance to the end or a center-to-center spacing between the gussets.