Block Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

The block properties are optional and can be used to specify two stacked rectangular blocks that are used to represent slide plates, shims, insulation pads, cradles, and so forth. Enter the values for these properties only when Block geometry is required.

The position of Block 1 is exactly Gap1 below the bottom of the pipe. The position of Block 2 is on top of Block 1. Both blocks have similar input properties: height, width and length. The blocks are not included if any of these values are set to zero.

IJUAhsGap1::Gap1 (Optional)

Specifies the distance between the pipe bottom and the top of Block 1. This distance value can be a negative, zero, or a positive value. If set to zero, no gap exists between pipe and Block 1. If set to a positive value, there is a gap of the specified distance between the pipe and the top of Block 1. If set to a negative value, Block 1 is partially embedded into the pipe.

IJUAhsHeight1::HeightX (Optional)

Specifies the height of the block.

IJUAhsWidth1::WidthX (Optional)

Specifies the width of the block.

IJUAhsLength1::LengthX (Optional)

Specifies the length of the block (the direction parallel to the pipe).

For the Nut properties, make sure that all four properties are similar for Nut 1, Nut 2, Nut 3, and Nut 4 and are defined in a generalized way as you have done for the Block properties.