Concrete Plate Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

Specify the attributes of the concrete attachment plate. Concrete attachment is an optional geometry. These properties are also optional. You must enter values only when the concrete attachment plate is needed.

For these properties, the default unit of distance is mm. Specify in at the end of the dimensional value to use inches (for example 10in).

IJUAhsWidth3::Width3

Specifies the width of the plate. If the value is set to zero or negative, the plate will not be drawn.

IJUAhsLength3::Length3

Specifies the length of the plate. If the value is set to zero or negative, the plate will not be drawn.

IJUAhsThickness3::Thickness3

Specifies the thickness of the plate. If the value is set to zero, the plate will not be drawn. If a positive value is set, then the inside face of the plate will be on the outside face of the base. If a negative value is set, then the outside face of the plate will be on the outside face of the base, so the plate will be embedded into the base. The surface port will always be located on the outward-most face of the plate or base.

IJUAhsOffset3::Offset3

Specifies the left-to-right offset of the plate from the bolt center. If the value is set to zero, the plate will be centered. If a positive value is set, then the edge of the plate will be located the specified distance from the bolt centerline. This value is used when the welded beam attachment bolt part is used for non-symmetrical beam attachments.