Top Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

These properties specify the horizontal top plate properties of the welded beam attachment that attaches to the structure. This is an optional plate and may not be needed. Enter these values only if the plate is needed.

If you need continuous geometry, enter the same thickness as the rest of the attachment for the top plate. When Gap1 = 0, the side and bottom plates are not shown.

IJUAhsWidth3::Width3

Enter the width of the top plate. If this value is zero, then Width1 is used.

IJUAhsLength2::Length2

Enter the length of the top plate. If this value is negative, the top plate is not shown. However, if this value is less than Gap1, the ears of the top plate are drawn inside the U. When the value is greater than Gap1 plus two times the value of Thickness1, the top plate is drawn as ears.

IJUAhsThickness3::Thickness3

Enter the top plate thickness. Only positive values are acceptable. If this value is zero, Thickness1 is used. This thickness is not added to Height1.