Pin/Bolt Properties (Clevis) - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

These properties specify bolt/pin properties of a welded beam attachment and are used to set the pin/bolt size and the port location.

If Pin1diameter and Pin1Length are set to zero, then the pin/bolt is not drawn. You must change the port to an appropriate hole type in the HS_S3DParts.xls workbook and a separate bolt/pin will need to be modeled.

IJUAhsPin1::Pin1Diameter

Specifies the diameter of the bolt/pin. Use this property as a connection diameter from AIR when joining between the clevis and eye nut. If this value is set to zero, then the pin is not drawn.

An AIR that joins a clevis to an eye nut reads Pin1Diameter from the clevis and passes it into the PinDiameter prompt of the EyeNut.

IJUAhsPin1::Pin1Length

Specifies the length of the bolt/pin. If this value is set to zero, then the pin is not drawn.