Gussets Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
12.1 (2019)

These properties are optional. Enter the values for these properties to have triangular gussets. Multiple gussets are allowed. If any dimension or quantity is set to zero, gussets are not drawn.

IJUAhsHeight3::Height3 (Optional)

Specifies the height of the gussets. If the strap has wings, the gussets are on top of the wings. If there are no wings, then the gussets are aligned with the bottom of the strap.

IJUAhsWidth3::Width3 (Optional)

Specifies the width of the gussets.

IJUAhsThickness3::Thickness3 (Optional)

Specifies the thickness of the gussets.

IJUAhsMulti3::Multi3Qty (Optional)

Specifies the quantity of the gussets. Gussets are not shown on the strap when Multi1Qty is set to zero. Valid cases are shown in the example below..

IJUAhsMulti3::Multi3LocateBy (Optional)

Specifies the location of the gussets. Individual gussets can be located in two ways.

1 - Relative to center of the group
2 - Relative to edge.

The exact meaning depends on the quantity of gussets. This value can be 0 (nothing), 1 (center), or 2 (edge). Valid cases are shown in the example below.

IJUAhsMulti3::Multi3Location (Optional)

Specifies the distance for exact location of the gussets depending on Multi1LocateBy and Multi1Qty. This value can be either a distance to the edge or a center-to-center spacing. Valid cases are shown in the example below.

Example: Valid Multi3Qty, Multi3LocateBy, Mult32Location cases: