-
Click Ruled Plate System Command to display the Ruled Plate System Ribbon.
-
Click First Curve Definition .
-
Click Sketch Curve .
-
Specify the sketching plane for the curve using one of the following methods:
Define a coincident plane
Define an offset plane
Define a plane using a point and a normal vector
Define a plane using three points -
Click Add Intersecting Item .
-
Select objects in the model that intersect the sketching plane that you want to use as reference geometry. These extra objects appear in the Sketch 2D environment.
-
Click Add Projection Item .
-
Select objects in the model that do not intersect the sketching plane that you want to use as reference geometry. These extra objects are projected onto the sketching plane and appear in the Sketch 2D environment.
-
Click Sketch 2D .
-
In the Sketch 2D environment, sketch the first curve for the ruled plate system.
-
Click Finish in the Sketch 2D environment.
-
Click Second Curve Definition .
-
Click Sketch Curve .
-
Specify the sketching plane for the second curve using one of the following methods:
Define a coincident plane
Define an offset plane
Define a plane using a point and a normal vector
Define a plane using three points -
Click Add Intersecting Item .
-
Select objects in the model that intersect the sketching plane that you want to use as reference geometry. These extra objects appear in the Sketch 2D environment.
-
Click Add Projection Item .
-
Select objects in the model that do not intersect the sketching plane that you want to use as reference geometry. These extra objects are projected onto the sketching plane and appear in the Sketch 2D environment.
-
Click Sketch 2D .
-
In the Sketch 2D environment, sketch the second curve for the ruled plate system.
-
Click Finish in the Sketch 2D environment.
-
Click Define Boundaries .
-
Define the ruled plate system boundaries using one or more of the following methods:
-
Click Accept .
-
If the boundary definition results in more than one solution, you must select bounded areas that together compose the total bounded area. Pick the needed solutions using the following procedure:
-
Set the remaining plate system properties.
-
Click Finish.