These properties define the geometry of the pin or lug at the top of the yoke clamp.
IJUAhsPin1::Pin1Diameter
Specifies the diameter of the bolt or lug.
If hsPinOrLug = 2 the hole is not shown in the graphics. To represent it, set Pin1Length equal to Length4 and Pin1Diameter less than Width4.
IJUAhsPin1::Pin1Length
Specifies the length of the pin. This value is always greater than Length4.
If hsPinOrLug equals 2, then set this value to Length4. If hsPinOrLug equals 1 and it is less than Length4, then the software sets Length4 plus Pin1Diameter as the default value for this property.