These properties define the geometry of the pipe clamp body.
For these properties, the default unit of distance is "mm". Specify "in" at the end of the dimensional value to use inches (for example 10in).
IJUAhsDiameter1::Diameter1
Specifies the inside diameter of the pipe clamp body. It is the same as the outside diameter of the pipe.
IJUAhsThickness1::Thickness1
Specifies the thickness of stock, which is used to make the pipe clamp body. It also specifies the thickness of the top and bottom tabs.
IJUAhsInsulationThickness::InsulationThickness
Specifies the insulation thickness of the stock, which is used to make the pipe clamp body.
IJUAhsWidth1::Width1
Specifies the width of the clamp body. In general, both the left and right halves of the clamp are of the same width, unless Width2 is specified. If Width1 is negative, the left half of the clamp is not displayed. Width1 cannot be zero or undefined.
IJUAhsWidth2::Width2
Specifies the second width of the clamp body. It is the optional width. Both halves of the clamp are of the same width if Width2 is zero. Both halves of the clamp are of different widths if Width2 is specified with a reasonable value. The right half of the clamp is not shown if Width2 is negative. Width2 is ignored when Angle1 is set to 360-degrees.
IJUAhsHeight1::Height1
Specifies the height from pipe center to top of clamp. The value of Height1 cannot be zero or less than the outside diameter of the clamp body.
IJUAhsHeight2::Height2
Specifies the height from pipe center to the bottom of the clamp. The value of Height2 cannot be zero or less than the outside diameter of clamp body. It is ignored when Angle1 is set to 360-degrees.
IJUAhsGap1::Gap1
Specifies the gap between the two top tabs. This value is always greater than or equal to zero.
IJUAhsGap2::Gap2
Specifies the gap between the two bottom tabs. This value is always greater than or equal to zero. It is ignored when Angle1 is set to 360-degrees.
IJUAhsAngle1::Angle1
Specifies the sweep angle between the top and bottom tabs. When Angle1 is set to 360-degrees, only the left half of the clamp is displayed and Gap1 is used for the tab space. In this case, the pipe clamp looks like this: