These properties define the geometry of the malleable beam clamp.
IJUAhsMalleableClamp::MalleableConfig
Specifies the malleable beam clamp configuration to show if the clamp has nut, eyenut, or no rod attachment. It uses the hsMalleableConfig codelist.
IJUAhsMalleableClamp::TopWidth
Specifies the top width of malleable beam clamp from starting of flange till the inner malleable clamp touches the flange. This is a double value. This value must be positive. If the TopWidth value is not specified, then an error is thrown.
IJUAhsMalleableClamp::Depth
Specifies the depth of the beam clamp. This value must be positive. If the depth value is not specified, then an error is thrown.
IJUAhsMalleableClamp::Thickness
Specifies the thickness of the clamp. This value must be positive. If the Thickness value is not specified, then an error is thrown.
IJUAhsRodTakeOut::RodTakeOut
Specifies the distance between the flange surface to starting of nut/eyenut surface. This is a double value and must be greater than zero.
IJUAhsMalleableClamp::NutShape
String specifying the name of the nut shape. NutShape value is optional. If this value is specified, then nut shape is added to the malleable beam clamp.
IJUAhsMalleableClamp::EyeNutShape
String specifying the name of the eyenut shape. EyeNutShape value is optional. If this value is specified, then eyenut shape is added to the malleable beam clamp.
IJOAhsAngle1::Angle1
Specifies the angle between the structure center line and eyenut shape. It is used for sloped steel configuration. Both positive and negative values are accepted. This is applicable only for malleable configuration with eyenut. If the value specified for configuration is other than eyenut, then the angle will be ignored and the graphics are not updated.
IJUAhsOverLength1::OverLength1
Specifies the amount that the rod extends past the threaded base of nut/eyenut. This value is used to ensure that rod take-out calculations are correct.