Pin Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
11 (2016)

These properties are used to create top and bottom pin for the malleable beam clamp.

IJUAhsPin1::Pin1Length

Specifies the length of the inner rod which comes along with the malleable beam clamp. If Pin1Length value is not specified, then the pin is drawn.

If Pin1Length value is less than StructWidth+2*Thickness, then a warning message is displayed and the value is reset to StructWidth+4*Thickness.

IJUAhsPin1::Pin1Diameter

Specifies the diameter of the inner rod which comes along with the malleable beam clamp. If Pin1Diameter value is not specified, then the pin is not drawn.

IJUAhsPin2::Pin2Diameter

Specifies the diameter of the pin. This value must be less than the thickness of the clamp. Else, a warning message is displayed. If Pin2Diameter value is not specified, then the pin is not drawn.

IJUAhsPin2::Pin2Length

Specifies the length of the pin. This value must be greater than the depth of the clamp. Else, a warning message is displayed. If Pin2Length value is not specified, then the pin is not drawn.