The StructMfgServiceTables_Plates.xls workbook defines the service tables of plate curvature bow depth, based on plate thickness and straight lengths. An additional table defines bridge parts. The workbook is delivered to the [Product Folder]\ShipCatalogData\BulkLoad\DataFiles\StructManufacturing folder and is bulkloaded into the Catalog.
The following sections document elements used in the StrMfgBridgeFeatures worksheet.
Definition Section
Offset
Bridge offset value measured from the OffsetReference edge. A negative value indicates that the bridge is placed at the center of the hole. Negative values are valid only for inner contours.
Width
Width of the bridge.
FilletRadius
Radius of the fillet applied to the bridge contours.
BridgeMark
Flag that indicates the creation of bridge markings.
CutMethod
Property assigned to the bridge edge.
-
Bridge: CUT_METHOD = "Bridge"
-
Mark: CUT_METHOD = "Mark"
-
No: CUT_METHOD = "Cut"
Type
Specifies whether the bridge applies to features, holes, or all.
OffsetReference
Specifies whether the software measures the Offset from the outer contour or from the inner contour.
Alignment
Specifies bridge placement. This property is available only for panel holes.
-
Outer Contour places the bridge parallel to the closest outer contour edges.
-
Inner Contour places the bridge parallel to the common seam.