-
Click Route Pipe on the vertical toolbar.
-
Select the branch run starting point (the end not connected to the header).
-
Select a point on the header at approximately the correct angle and direction that you want.
-
In the Locate Filter, select Piping Features.
-
Select the Pipe Along Leg Feature where the branch connects to the header. You will probably need to use Quick Pick to select the correct feature.
-
In the Angle 1 box on the ribbon, type the actual angle that you want the branch to connect to the header.
If the piping specification that you selected has service limits defined, you must define at least one temperature value and one pressure value for the branch. Do this by selecting Temperature and Pressure from the Category option.