Transfer a length to a section of pipe - Intergraph Smart Isometrics - Help - Hexagon PPM

Intergraph Smart Isometrics Help

Language
English
Product
Intergraph Smart Isometrics
Search by Category
Help
SmartPlant Foundation / SDx Version
10
I-Configure Version
6.0(2016)
Isogen Version
13.0(2016)
Smart Isometrics Version
7.0(2019)
Spoolgen Version
9.0(2019)
  1. Use Set Start Point and Set End Point on the Point Cloud toolbar to position measurement points over the ends of the pipe. An example is shown below.

    The software displays the coordinate values in the Point Cloud Measurements window accordingly, and computes the distance between the two measurement points.

  2. Drag Start/End Points Distance from the Point Cloud Measurements window to the corresponding location on the referenced piping sketch in the Detail window.

    The selected pipe highlights so that you can confirm where the data is applied.

  3. Click File > Save to save your changes.