Connect to a point cloud data set - Intergraph Smart Isometrics - Help - Hexagon PPM

Intergraph Smart Isometrics Help

Language
English
Product
Intergraph Smart Isometrics
Search by Category
Help
SmartPlant Foundation / SDx Version
10
I-Configure Version
6.0(2016)
Isogen Version
13.0(2016)
Smart Isometrics Version
7.0(2019)
Spoolgen Version
9.0(2019)
  1. Click File > Point Cloud Data > Connect.

    The Connect to Cyclone HDS Data dialog box opens.

  2. In the Cyclone HDS Data tree, expand the nodes as needed to locate the required ModelSpaces view. In the example below, Plant 1 View 1 Registered is selected.

    You must select a registered ModelSpaces view in the point cloud data set. Registered views are located under a Registration node in the Cyclone HDS Data tree.

  3. If needed, select the coordinate system from the list. If a user-specified coordinate system was defined in the Cyclone software, it is available in this list. Otherwise, the software uses the default coordinate system.

  4. Click OK.

    The software opens the Smart Isometrics 3D View window and displays the selected point cloud data set.

  • The connection to the point cloud data set remains active throughout the current session. To terminate the connection, click File > Point Cloud Data > Disconnect.

  • If the 3D View window is displaying an active pipeline, the software updates the view to show the pipeline and the point cloud data set. Make sure that any pipeline that you are currently viewing is associated with the point cloud load. Otherwise, the pipeline and the point cloud can appear very small when they are both fitted to the 3D View window.

  • The standard View and 3D View commands work on any visible pipelines and the point cloud data set. For more information about these commands, see Navigation Techniques.