Place a drawing split point - Intergraph Spoolgen - Help

Intergraph Spoolgen Help

Language
English
Product
Intergraph Spoolgen
Search by Category
Help
SmartPlant Foundation / SDx Version
10
I-Configure Version
6.0(2016)
Isogen Version
13.0(2016)
Smart Isometrics Version
2019 R1 (7.1)
Spoolgen Version
2019 R1 (9.1)

For managing large pipelines, you can use split points break the pipeline into multiple sheets. In cases where split points were placed in the original IDF or PCF, you can configure Spoolgen to obey or disregard them after they are imported. Then use the Place Drawing Split Point command to control where the split points occur.

  1. Click Place Drawing Split Point on the Place toolbar.

    The Selection ribbon displays.

  2. Select the location on the pipeline where the split is to occur, and then click OK .

    The software displays the corresponding short description (ISP) to indicate where the split will occur. However, the actual splitting takes effect when you generate the isometric drawing. If one split point is present, the software generates two sheets.

  • If the split is to take effect prior to generating an isometric drawing, click Update Current View to refresh the current view of the pipeline. The software recalculates the POD file, splits the pipeline accordingly. To switch between multiple sheets, open the Window menu and select the name of the sheet to view. Alternatively, press CTRL+TAB to switch between sheets.

  • To delete a drawing split point, right-click the split point, and select Delete.