Enables you to set up graphic views of the processed data, view descriptions of resulting differences, and then generate reports on the differences. The Add, Remove, Highlight, and Fit options work within graphic views so that you can run the utility interactively with Smart 3D.
The steps below provide a general workflow in using options in the Validate MDR Results - Review Findings Dialog.
-
Select ALL or a specific category of objects.
-
Click Setup Views. For model data reuse comparisons within the same session file, the utility generates four graphic views. Two graphic views are generated from an objects list comparison.
When the source and destination are within the same model, the top graphic views
represent the source and the bottom views represent the destination.
-
Click the scroll buttons
to see each object available in the selected category. As you scroll through the
objects, they are displayed in the graphic views in Smart 3D.
-
You can clear, add or remove each object from your Smart 3D selection set.
-
Select Highlight and Fit to better see the objects in graphics views. You can also use commands in Smart 3D to further manipulate objects in the graphic views.
-
Click Show Details to get more in-depth descriptions of changes or anomalies that were found.
-
Select an object in the Validate MDR Results - Review Findings Dialog. Click on any window or element in Smart 3D to get the focus and press CTRL+T to open the To Do List dialog box. Click Filter To Do List by Select Set to see if any selected objects have a To Do record.
-
As you move through the list views in the Compared Data section of the Validate MDR Results - Review Findings Dialog, the cursor automatically selects each related source and destination object. To prevent this and freely scroll down through the objects in the list views, press and hold the CTRL key.
-
-
You can now generate a report or create discipline-specific folders to show data anomalies. Select Differences Only and then click Next.